LM10010-QUICKSTART-CAL

LM10010 quickstart cal

LM10010-QUICKSTART-CAL

Downloads

Overview

The LM10010 is a precision, digitally programmed device used to control the output voltage of a DC/DC converter. The LM10010 outputs a DC current inversely proportional to a 6-bit input word. This current DAC output connects to the feedback pin of a regulator in order to adjust its output voltage to a desired range and resolution set by the user. As the 6-bit word counts up, the output voltage is adjusted higher based on the setting of the feedback resistors in the converter.

This calculator helps show some of the sources of error in constructing this point of load source. The user enters the expected error from the LM10010, the regulator feedback, and resistors used to set the voltage. The spreadsheet shows the expected error from the system depending on the code and the output voltage.

Download View video with transcript Video

Downloads

Calculation tool

LM10010-QUICKSTART-CAL LM10010 Error Calculator

Supported products & hardware

Supported products & hardware

Products
Precision DACs (≤10 MSPS)
LM10010 6-Bit VID Voltage Programmer for Point of Load Regulator

Supported products & hardware

Precision DACs (≤10 MSPS)
LM10010 6-Bit VID Voltage Programmer for Point of Load Regulator

Support & training

TI E2E™ forums with technical support from TI engineers

View all forum topics

Content is provided "as is" by TI and community contributors and does not constitute TI specifications. See terms of use.

If you have questions about quality, packaging or ordering TI products, see TI support.

Videos